PASMC_test.cellml

Single-cell response to KCl stimulation

In the single-cell response to KCl stimulation, the isolated cell model is configured and parameterised with an applied concentration clamp protocol.

You can change the parameters of stimulation in the component clamp_para. You can also bypass the parameters in the component Para and define your own parameters.

The simulation experiment can be obtained by loading the corresponding SED-ML document into OpenCOR and executing the simulation. We use the Python script simFig4 to perform the simulation for the following figures.

We set the intracellular K⁺ concentration K_in = 158.4mM and the initial value of the open state probability of K⁺ channels w_i = 0.5 during the simulation.

Dynamics when K_out = 4.7mM

Figure [1] shows the oscillating dynamics of Ca^2 + concentrations and the cell membrane potential, when the extracellular K⁺ concentration K_out = 4.7mM.

Single-cell response to KCl stimulation

We set the extracellular K⁺ concentration K_out = 4.7mM before t = 10s and K_out steps up to 80 mM at t = 10s. Since the reversal potential for K⁺ current is associated with K_out, the reversal potential v_K in original equation (13) is also changed at t = 10s.

Figure [2] shows the simulation result where there is an initial surge of c_i when we use the initial values from the cited model (Parthimos et al. 1999).

We tried different initial values and Figure [3] shows a few traces compared to the original figure. Although the closest orange trace has some overlap with the original data, there is still discrepancy between them. We think this might have something to do with the intracellular K⁺ concentration value K_in = 158.4mM or the holding extracellular K⁺ concentration K_out = 4.7mM before t = 10s.

Simulated intracellular Ca^2 + concentration c_i response to KCl stimulation.